punch former(V-PS)

  
punch former(V-PS)
   Part Number : ‎    
   Type : V series      
Available
D(diameter)of the pressed part of the punch...4-30mm
L(length)of the pressed part of the punch...above22mm
upper and lower movement span of V block....25mm
horizontal movement span of V block(one side)...12.5mm(two side)...25mm
lenght of Vblock.......30mm
height of the rotary central axis...15mm
cutting and dividing...24equal piece(15')sand forming of the forming lever
(concave R)....100MMR
(CONVEX R)...48MMR
except for the handle and graduation scale all metal is special hard tool steel(SKS-2)heat treated at HRC 63
V-PS the center through hole isΦ30mm
V-PS allows go through from the center of grip,to clamp amore longer punch ejector of grip,to clamp amore longer punch ejector pin,it can go deep in to of the grip position directly.to assemble an ARM with the main body,any combination of radial form of the grinding wheel may be dressed accurately by easy operation.
    Similar products
    Vertex former punch grinder

    Vertex Punch

    Part Number:
    V series


    Available
    ER collet dividing punch former(V-PS-ER32)

    Vertex Punch

    Part Number:
    V series


    Available
    VERTEX ER Collet Dividing Punch

    Vertex Punch

    Part Number:
    V series


    Available
    Vertex round insert Milling cutter

    Vertex Punch

    Part Number:
    V series


    Available
    فوتر وبسایت ورتکس vertex

    TEL : 886-4-25238-742 / 25237596 / 2
    Email: info [at] vertex [dot] co [dot] com

    © Copy right 2024 | All ights Reserved | VERTEX Group